Characterization of ZnO:AI films deposited by r.f.magnetron-sputtering at low temperature

Transparent conducting ZnO:AI thin films with good adhesion and Iow resistivity have been prepared on organic substrates and Coming 7059 glass substrates by r.f. magnetron-sputtering technique at Iow substrate temperature (25-210℃). Structural and photoelectric properties of the deposited films are investigated. The deposited films are polycrystalline with hexagonal structure and a preferred orientation with the c-axis perpendicular to the substrate. Only the (002) peak is observed.High quality films with resistivity as Iow as 1.0 x 10- 3Ω@ cm and 8.4 x 10- 4Ω@ cm, the average transmittance over 74% and 85% in the wavelength range of the visible spectrum have been obtained on different substrates.     

面心立方晶体外延膜沉积生长中失配位错的结构与形成过程

用分子动力学方法对5%负失配条件下面心立方晶体铝薄膜的原子沉积外延生长进行了三维模拟.铝原子间的相互作用采用嵌入原子法(EAM)多体势计算.模拟结果再现了失配位错的形成现象.分析表明，失配位错在形成之初即呈现为Shockley扩展位错，即由两个伯格斯矢量为〈211〉/6的部分位错和其间的堆垛层错组成，两个部分位错的间距、即层错宽度为1.8 nm,与理论计算结果一致；外延晶体薄膜沉积生长中，位错对会发生滑移，但其间距保持稳定.进一步观察发现，该扩展位错产生于一种类似于“局部熔融-重结晶”的表层局部无序紊乱- 关键词： 失配位错 外延生长 薄膜 分子动力学 铝     

Spectrofluorimetric Method for the Determination of Aluminum with Alizarin Red PS

 A simple and direct spectrofluorimetric method has been developed for the determination of aluminum using alizarin red PS (1,2,4-trihydroxy 9,10-anthraquinone-3-sulfonic acid). The method is based on the strong fluorescence (480/564 nm) of Al³⁺ and alizarin red. Experimental parameters such as pH, concentration of the ligand, ionic strength of the solution, reaction time and temperature were optimized in order to maximize the analytical signal. Interferences of several ions (anions and cations) were studied and evaluated. The linear range of the method extends from 3 to 100 μg L⁻¹. Limit of detection (3s_b) was 0.9 μg L⁻¹. The method was tested with a silicate certified reference material. Interferences were eliminated by a liquid extraction with cupferron. Author for correspondence. E-mail: aucelior@rdc.puc-rio.br Received September 10, 2002; accepted January 15, 2003 Published online May 5, 2003     

Luminescence properties of anodic aluminum oxide films with organic luminophores embedded into pores

Luminescence properties of porous anodic aluminum oxide films formed in a 0.6 M solution of citric acid and luminescence of paraterphenyl, perylene, coumarin 7, and rhodamine 6G dyes adsorbed by the films are investigated. The nature of emitting centers in anodic aluminum oxide is revealed. Intense photoluminescence of all tested dyes embedded into pores of anodic aluminum oxide has been found. A redshift of fluorescence spectra of dyes adsorbed by the matrix and emergence of an additional longwave band have been detected. Data obtained can be used in developing new thin-film luminescent coatings for future applications in optoelectronics and molecular electronics. Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 64, No 4, pp. 483–488, July–August, 1997.     

催化动力学光度法测定痕量铝

痕量铝在硝酸介质中能催化加速过氧化氢和高碘酸钾与二甲苯胺兰FF之间的褪色反应。研究了反应的最佳实验条件,建立了测定痕量铝的新方法。方法检出限为6.1×10-10gAl3+/mL,检测范围为0-1.0μgAl3+/25mL。本方法具有高灵敏度,选择性较好,操作简便,快速的特点。用以测定水样中的痕量铝,获得满意结果。     

Wavelength dependence in photochemical vapor deposition of aluminum film using dimethylaluminum hydride

In photochemical vapor deposition of aluminum film on silicon using dimethylaluminum hydride, (CH₃)₂AlH, a surface reaction dominated below a (CH₃)₂AlH pressure of 0.3 m Torr at 200°C, which was induced only with the 160 nm band emitted from a deuterium lamp. A gas-phase reaction occurred above 0.3 mTorr at 200°C, which could be induced by both 160 nm and 240 nm emission bands from the lamp. To distinguish between surface ad gas-phase reactions, a thickness profile was used. At 240°C the surface reaction could be induced even by the 240 nm band, while the deposits formed under illumination of the two bands were thinner than those obtained with only the 240 nm band, indicating occurrence of vacuum ultraviolet (VUV)-enhanced desorption. The mechanism responsible for the observed wavelength dependence in unclear. The electrical resistivity of the films deposited at 200°C was 4.5 μΩ cm, which did not change with wavelength.     

利用富铈混合稀土改善工业纯铝中富铁相形貌的研究

利用金相分析方法研究了富Ce混合稀土变质对含不同Fe量的工业纯铝的组织和其中富铁相形貌的影响。试验结果表明,随着Fe含量的增加,富铁相由弥散细小的颗粒状向短棒状、长针状转变;富Ce混合稀土变质使铝中的富铁相由长针状变为弥散细小的颗粒状。随着稀土含量的增加,-αAl晶粒逐渐细化,富铁相尺寸及数量逐渐减小。添加0.5%稀土时,-αAl晶粒细化效果最佳,而且富铁相呈细小颗粒状均匀分布在-αAl基体的晶界处。本文还对稀土改善富铁相的机制进行了分析。     

Synthesis and magnetic properties of multilayer Ni/Cu and NiFe/Cu nanowires

Highly ordered composite nanowires with multilayer Ni/Cu and NiFe/Cu have been fabricated by pulsed electrodeposition into nanoporous alumina membrane. The diameter of wires can be easily varied by pore size of alumina, ranging from 30 to 100 nm. The applied potential and the duration of each potential square pulse determine the thickness of the metal layers. The nanowires have been characterized by transmission electron microscopy (TEM), magnetic force microscopy (MFM), and vibrating sample magnetometer (VSM) measurements. The MFM images indicate that every ferromagnetic layer separated by Cu layer was present as single isolated domain-like magnet. This technique has potential use in the measurement and application of magnetic nanodevices.